SAAS PIllar Pod suits Toyota Landcruiser 1998-07 100 Series Grey Single Piece
$218.45
In stock
Only 1 left
SAAS Gauge Pillar Pod Mount Single Piece
Suits:
Toyota Landcruiser 1998 - 2007 100 Series
Painted Colour: Grey
The new SAAS single piece pillar pod, these one piece ABS plastic pods replace your existing A-Pillar trim and provide a super sleek mount for 2 x 52mm SAAS gauges.
Pre-painted to match popular interior trim codes.
Features:
- OE factory look, Fits all OE pillar covers
- Nests your gauges as close as possible to the pillar for minimal vision impedance
- Pillar pod type: Cover (supplied with 2 x rivets clips to hold in place)
- Made with tough ABS plastic
- Airbag compatible
- Suits 2 x 52mm gauges
- Maximum gauge depth 50mm
Fitting Note:
- Early model vehicles may have pillar trims that extend through to the B-pillar. Fitment of the SGP1202S will require a cut and removal of part of the factory trim that runs along the A pillar where the windscreen meets the roof lining.
- Prior to any modification, it is recommended that you overlay the factory trim with the SGP1202S to identify the optimum cut line. Use a tape and/or pencil to mark the estimated finish point of the SGP1202S
- To avoid a butt join and potential misalignment, trim and cut the factory plastic just above the grab handle so that the SGP1202S slightly overlaps the factory trim.
SAAS Gauge Pillar Pod Mount Single Piece
Suits:
Toyota Landcruiser 1998 - 2007 100 Series
Painted Colour: Grey
The new SAAS single piece pillar pod, these one piece ABS plastic pods replace your existing A-Pillar trim and provide a super sleek mount for 2 x 52mm SAAS gauges.
Pre-painted to match popular interior trim codes.
Features:
- OE factory look, Fits all OE pillar covers
- Nests your gauges as close as possible to the pillar for minimal vision impedance
- Pillar pod type: Cover (supplied with 2 x rivets clips to hold in place)
- Made with tough ABS plastic
- Airbag compatible
- Suits 2 x 52mm gauges
- Maximum gauge depth 50mm
Fitting Note:
- Early model vehicles may have pillar trims that extend through to the B-pillar. Fitment of the SGP1202S will require a cut and removal of part of the factory trim that runs along the A pillar where the windscreen meets the roof lining.
- Prior to any modification, it is recommended that you overlay the factory trim with the SGP1202S to identify the optimum cut line. Use a tape and/or pencil to mark the estimated finish point of the SGP1202S
- To avoid a butt join and potential misalignment, trim and cut the factory plastic just above the grab handle so that the SGP1202S slightly overlaps the factory trim.
| SKU | AC SGP1202SG-001 |
|---|---|
| Free Shipping | Australia Wide |
Write Your Own Review